Dive to the bottom of a swimming pool and your ears tell you something before any formula does. The deeper you go, the more it hurts. Nothing changed except depth. That one feeling is the whole idea of hydrostatic pressure, and in my experience students understand it better when they start from the ear and only then move to the equation.

Pressure on the probe grows in direct proportion to depth (ρgh)

Where the pressure comes from

Take a small flat patch of area A at depth h inside a liquid at rest. Directly above it sits a column of liquid, and that column has weight. Mass of the column is ρ × A × h, so its weight is ρAhg. Spread over the area A, the extra pressure is simply ρgh. Add the pressure of the air pushing on the surface and you get

P = P₀ + ρgh

Here P₀ is the pressure at the surface (about 1.013×10⁵ Pa for open air at sea level), ρ is the density of the liquid and h is the depth below the surface. Notice what is missing: the width of the container, the volume of the liquid, the shape. Only density, g and depth survive.

The shape does not matter

This is the part students refuse to believe at first. A narrow tube and a huge lake, both filled to the same height, give the same pressure at the bottom. Join a tall thin tube, a wide bulb and a slanted tube at the bottom and the water stands at the same level in all three. If pressure depended on the amount of water, the wide bulb would push the others up. It does not, because at any one depth the pressure is the same in all directions and all places. That is exactly why the level in a U-tube and in a kettle with a spout match.

Worked check: 10 m of fresh water (ρ = 1000 kg/m³, g = 9.8 m/s²): ρgh = 1000 × 9.8 × 10 = 98,000 Pa. That is almost one extra atmosphere. So the total pressure at 10 m depth is 1.013×10⁵ + 0.98×10⁵ ≈ 1.99×10⁵ Pa, nearly 2 atm. Every 10 m of water adds about one atmosphere, a handy number to remember.

Gauge pressure versus absolute pressure

Here is the mistake I see most often in tests. The ρgh part alone is called gauge pressure. The full P₀ + ρgh is absolute pressure. Which one you need depends on the question. The force on a dam wall or a submarine hatch with air at normal pressure inside and out? Use gauge pressure, because the atmosphere pushes on both sides and cancels. A question about the total pressure at that depth? Use absolute. Read the sentence twice before choosing.

Two numbers to carry with you

First, the mercury barometer. A column of mercury 760 mm tall: 13,600 × 9.8 × 0.76 ≈ 1.013×10⁵ Pa. That is how we got the standard atmosphere, and it is why mercury (13.6 times denser than water) lets a barometer fit on a table while a water barometer would need a pipe about 10 m tall. Second, the deepest place in the ocean, the Challenger Deep in the Mariana Trench, at roughly 10,900 m. With sea water of ρ ≈ 1025 kg/m³, ρgh comes to about 1.1×10⁸ Pa, over a thousand times atmospheric pressure. Not a number you can feel, but one that explains why deep-sea vehicles are built as thick spheres.

Why dams are thicker at the bottom

Pressure grows linearly with depth, so the sideways push on a dam wall grows with depth too. Water at 5 m pushes with 49 kPa, at 30 m with 294 kPa, six times more. Engineers respond by making the wall thicker toward the base. When you see the cross-section of a dam in your textbook, you are looking at a plot of ρgh turned into concrete.

Try it yourself

Pressure in Fluids U-Tube Fluid Density Pascal's Law & Hydraulics